3D Pen Faqs

Related FAQs

• How do I start drawing in the air?

  Start by “anchoring” your Doodle to a surface. Any sheet of paper works! Feed the filament, and press the nozzle down onto the paper until you see a little blob of plastic come out, and ensure the plastic is sticking to the paper. You can now freely lift off the page! Once you have reached the height you want, stop feeding the filament, and hold the plastic in place for a few seconds to allow it to harden (10-15 seconds with the 3Doodler Start, and about 3 seconds with the 3Doodler Create+ or PRO+). Start slow, don’t Doodle too high,…

• Can I use the 3Doodler Start with my Create DoodlePad or other 3Doodler Create Accessories?

  No, the 3Doodler Start is not compatible with any of the 3Doodler 1.0, 2.0, or Create products or accessories, including Plastic Strands, DoodlePad, Nozzle Set, JetPack, Doodlestand, or Pedal. The only exception is the Project Book, which we encourage using for 3Doodler Start projects too.

• Can I use the Create+ Jetpack with my 3Doodler PRO+?

  No, the Create+ JetPack uses 5V/1.2A and cannot power the PRO+. The amperage is listed on the underside of the JetPack, and for the PRO+ pen, this information can be found in the user manual.